beautypg.com

USGlobalsat EM-318-02 User Manual

Page 15

background image

EM-318-02

Specifications are subject to be changed without notice.

Page 15 of 16

Version 1.2.1


E.) LLA Navigation initialization ID:104 Parameters required to start using Lat/Lon/Alt

This command is used to initialize the GPS module for a “Warm” start, providing real-time position
(Latitude, Longitude, Altitude coordinates), clock offset, and time. This action enables the GPS
receiver to search for the necessary satellite signals at the correct signal parameters. The newly
acquired and stored satellite data will enable the receiver to acquire signals more quickly, and thus,
generate a rapid navigational solution.

When a valid LLA Navigation Initialization command is receive, then the receiver will restart using the
input parameters as a basis for satellite selection and acquisition.


Format:
$PSRF104,,,,,,,
, *CKSUM

Latitude position, assumed positive north of equator and negative

south of equator float, possibly signed


Longitude position, it is assumed positive east of Greenwich

and negative west of Greenwich Float, possibly signed


Altitude position float, possibly signed


Clock Offset of the receiver in Hz, use 0 for last saved value if

available.

If this is unavailable, a default value of 75000 for GSP1, 95000 for GSP1/LX
is used.

INT32

GPS Time Of Week

UINT32

GPS Week Number

UINT16

Number of channels to use. 1-12

UBYTE

bit mask

0×01=Data

Valid

warm/hot

starts=1

0×02=clear ephemeris warm start=1

0×04=clear memory. Cold start=1

UBYTE

Example: Start using known position and time.
$PSRF104,37.3875111,-121.97232,0,96000,237759,922,12,3*37

F.) Development Data On/Off ID:105 Switch Development Data Messages On/Off

Use this command to enable development debug information if you are having trouble in attaining
commands accepted. Invalid commands will generate debug information that should enable the user
to determine the source of the command rejection. Common input rejection problems are associated
to invalid checksum or parameter out of specified range. Note, this setting is not preserved across a