Trail Master 1.5 Inch Lift Kit with NGS Shocks (TM3415-20010/TM3415-20012/TM3415-20013) User Manual
Page 7
7
4. If you purchased kit TM3415-20010 reinstall the
rear shock to the rear axle mount using the pre-
viously removed OE hardware. Torque the lower
hardware to
35
ft./lbs.
5. If you purchased kit TM3415-20012 or TM3415-
20013) Install your new rear shocks
(TM72215008 or 73215008) using the OE hard-
ware. Torque the upper mounting hardware to
17
ft./lbs. and the lower to
35
ft./lbs.
6. Reinstall the sway bar end links using the previ-
ously removed OE hardware.
7. Reinstall the rear brake line brackets to the vehi-
cle using the previously removed OE hardware.
8. On both sides of the vehicle, check the routing
of the brake lines and the ABS wire harnesses.
There must be no pinching, rubbing, or
stretching of either component. Use zip ties to
secure these items to the steering components.
9. Torque all bolts to factory specs and double
check your work.
10. Test drive and note location of steering wheel.
11. Adjust drag link to center steering wheel.
12. Align vehicle as soon as practical to minimum
factory caster and maximum factory toe-in
specifications.
13. Recheck all bolts after 50 miles and again after
every off road excursion.
Rear
Shock