Tomlinson 508FCG PREMIUM 12 PIZZA & SNACK - Manual (Page 3)

4 5
Your FUSION COMMERCIAL oven is a professional restaurant quality
oven designed to fit on a countertop in your kitchen, office, bar
or recreation room. With the oven’s dual baking elements, you
will be able to bake most frozen pizza, single serve entree snack
foods, and appetizers in 30 minutes or less. We recommend
preheating the oven for 5 minutes. Actual baking times could
vary from each product’s recommendations, so check food often
to avoid over-baking by turning on the light and looking through
the glass door.
Construction
Your FUSION COMMERCIAL oven outer case is made of 22 gauge
brushed 430 stainless steel. The inner case and internal
case parts are made from aluminized steel to protect against
corrosion. The tinted tempered glass door has a stainless steel
frame.
Power Capacity
Your FUSION COMMERCIAL oven operates on 120 volts, draws 12.2
amps and is rated at 1450 watts. For best results, operate your
pizza oven on an individual outlet or circuit branch.
Replacement Parts
Model #508FCG FUSION COMMERCIAL Premium 12" Pizza & Snack
Oven replacement parts:
Model # Description QTY
#1923486 Crumb Tray 1
#1923487 Small Phillips Head Screw 1
#1923488 Black Knob 1
#1923489 Food Rack 1
#1924209 Glass Door Assembly 1
#1923248 Handle Assembly 1
#1923454 Large Phillips Head Screw 1
#1923455 Large Thumb Nut 1
#1923491 Cleaning Brush 1
#1924210 Bulb 1
#1924364 Lens 1
#1924365 Lens Guard 1
Handle Assembly
Included with your oven is a parts bag containing an
ergonomically designed cool-touch handle, large phillips head
screw and large thumb nut. Follow the steps listed below to
assemble the handle to the food rack and glass door assembly.
Step 1: Remove glass door assembly #1924209, handle
assembly #1923248, and food rack #1923489 from the
packaging.
Step 2: Lay food rack on a stable counter top with loop facing
up and slightly over the edge of the counter.
Step 3: Fit the handle slot on the front of the
glass door over the food rack loop so
the glass door rests flat against the
food rack.
Step 4: Take handle assembly #1923248 and
rotate the handle and bracket so they
lie flat. Fit the bracket slot over the
food rack loop on top of the glass
door as shown (Figure 1).
Step 5: Rotate handle assembly and glass
door upright together as a single unit
(Figure 2).
Step 6: Using hardware found in the parts
bag, take out large phillips head
screw #1923454 and large thumb
nut #1923455. Slide large phillips
head screw through the round hole,
capturing the loop, handle bracket
and the glass door. Thread the large
thumb nut onto the large phillips
head screw from the opposite of the food rack
and finger tighten only (Figure 3) to prevent damaging
the glass.
Step 7: Rotate the assembled handle down and slide the
completed food rack back into the oven.
Warning:
Improper assembly of the handle to the food rack could cause
the food rack to rotate and fall when food is removed from the
oven. Do not attempt to grab HOT foods with bare hands when
removing food from the oven.
Figure 2
Figure 3
Handle slot
Phillips Head Screw
Hole
Large Thumb Nut
Figure 1
Food Rack Loop