SoleusAir HC7-15-01 - Manual (Page 5)

OPERATING INSTRUCTIONS
Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet.
Only operate the heater when it is in the upright position.
Use the instructions below to operate the heater using the control panel.
1. Turn on the POWER SELECT dial to the desired power setting (High/Low/Fan). When
this switch is turned to the desired setting, the red POWER INDICATION LIGHT will
light up indicating there is power to the unit.
2. This heater is able to run in LOW, HIGH, and Fan only mode. Choose the desired mode
based on your comfort level.
3. To activate oscillation, turn the OSCILLATION dial to SWING. Once it is located, the
heater will rotate side-to-side spreading warm air throughout the room.
5
Polarized Plug
Warning: This appliance has a polarized plug (one blade is wider than the other). To reduce the
risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the
plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to modify the plug in any way.
DO NOT DEFEAT THE SAFETY PURPOSE OF THE POLARIZED PLUG.
Tip-Over Safety Switch
This heater equipped with tip-over safety switch located underneath the base of the heater
(SEE ILLUSTRATION ON PAGE 4). This switch must be pressed inward for the heater to
function properly. Some soft surfaces such as carpet may not be able to fully press in this
switch. For some soft surfaces, a hard flat object will need to be placed underneath the heater
for it to function properly.
PLEASE DO NOT TAPE OR GLUE THIS SWITCH.
SAFETY FEATURES