SoleusAir PE3-12R-03 - Manual (Page 15)

REMOTE CONTROL OPERATING INSTRUCTIONS
1) Power On and Off - If the unit is already on, press the POWER (I/O) button on the remote while point-
ing the remote away from the unit. This will turn the remote on. If the unit is off, now press the POWER
(I/O) button once to manually turn the unit on. Press the Power button once more to turn the unit off.
When you press the POWER button the upper right square on the remote control LCD Display will light
up. When in Air Conditioner and Auto mode, the selected temperature will appear on the remote control
display. When the unit is in Fan mode and Dehumidifier mode you will see the “- -” icon instead of the set
temperature. This shows that temperature selection is not available when the unit is in Fan or Dehumidifier
mode.
2) Mode Selection - Press the MODE Button repeatedly to cycle between the different modes: Auto, Air
Conditioner, Dehumidifier, and Fan only mode. The upper left square on the Remote control display will
light up showing which mode is selected. In Air Conditioner mode the display will show “COOL”, in De-
humidifier mode the display will show “DRY”, in Fan mode the display will show “FAN”, and in Auto
mode the display will show “AUTO”.
3) Fan Speed - Press the FAN speed button to cycle through high, medium, and low fan speeds. The dis-
play on the remote control will show HIGH, MED, LOW under the “SPEED” label on the remote control
LCD display. There is an additional auto speed setting that is enabled in only cooling mode. This speed is
next setting after low when pressing the FAN speed button on the remote control. The speeds will cycle
through in this order: High, Medium, Low, Auto. Each change in speed will be associated with a “beep”
sound from the unit. The remote control will not display “AUTO” under the speed label. Once Auto fan
speed is selected the unit will beep and there will not be a fan speed displayed on the remote control.
4) Temperature Setting - When the unit is in Air Conditioner mode you can select your desired tempera-
ture. Press the ▲ or ▼ to select your desired temperature setting. The temperature on the LCD display on
the remote control will increase or decrease accordingly. Pressing the ▼and ▲ buttons simultaneously
will change the temperature select between °F and °C.
5) SLEEP MODE - See “SLEEP MODE” on page 12.
6) SWING - To turn on the exclusive WAVEFLO® oscillation, press the SWING button on the remote
control. Once you press SWING, the louvers on the unit will oscillate up and down. The bottom left square
of the remote control display will show the “ “ icon when WAVEFLO® oscillation (SWING) is
selected. To change the horizontal direction of the air flow manually adjust the internal horizontal louvers
left or right.
7) CLOCK - To set the clock on the remote control, hold down either the MIN or HOUR button until the
displayed time flashes on the remote control display. Change the minutes by pressing the MIN button and
change the hours by pressing the HOUR button. Set the clock prior to programming the timer.
8) TIMER - To program the timer, first press the T-ON button. Once T-ON is pressed the auto-on timer will
blink in the bottom right rectangle of the remote control display. Press the MIN and HOUR buttons to
change the clock to the desired time for the unit to automatically turn on. The minutes will increase by 10
with each press of the MIN button and the hours will increase by 1 with each press of the HOUR button.
Press the T-OFF button and the remote control display will flash the desired auto-off timer. Press the MIN
and HOUR buttons to change the clock to the desired time for the unit to automatically turn off. The timer
is set when the auto-off time stops flashing and the words “ON” and “OFF” are displayed next to the time.
15