beautypg.com

Mounting hardware, Caution, How to install – SoleusAir SG-WAC-12ESE-C User Manual

Page 8

background image

TOOLS NEEDED:

Phillips Screw Driver
Drill (If pilot holes are needed)

Qty.

3/4"screws

6

lock frame

2

sash lock

1

Mounting Hardware

When handling unit, be careful to avoid cuts
from sharp metal edges and aluminum fins on
front and rear coils.

CAUTION

How to Install

NOTE: Top Rail and Sliding Panels at each side are
offset to provide the proper pitch to the rear of (5/16").
This is necessary for proper condensed water utilization
and drainage. If you are not using the Side Panels for
any reason, this pitch to the rear must be maintained!

Place unit on floor, a bench or a table. There is a
Left and Right Window Filler Panel - be sure to
use the proper panel for each side.When installed

the flange for securing the panel in place to the window sill
will be facing into the room.

A. Hold the

Accordion
Panel in one
hand and
gently pull
back the
center to free
the open end.
See Figure 2.

1

FIG. 2

FIG. 3A

B. Slide the free end (“I”section) of the panel into the

cabinet as shown in Figures 3A, 3B & 4. Slide the
panel down. Be sure to leave enough space to slip the
top and bottom of the frame into the rails on the cabinet.

FIG. 3B

FIG. 4

C. Once the panel

has been
installed on the
side of the
cabinet, make
sure it sits
securely inside
the frame
channel by
making slight
adjustments. Slide the top and bottom ends of the frame
into the top and bottom rails of the cabinet. Figure 5.

D. Slide the panel all the way in and repeat on the other

side.

FIG. 5

7

This manual is related to the following products: