SHARKOON 5-Bay RAID Box - Manual (Page 6)

5-BAY RAID BOX
5.2 Clear existing RAID
Note:
Before deleting an existing RAID make sure to
backup your data as they will be lost afterwards!
1. Switch off the device.
2. Toggle the RAID switch on the device’s backside
to “Clear RAID”.
3. Press “Set” and power on the device simultaneously.
4. The device will beep and the existing RAID is
erased.
5.3 Set RAID mode
1. Switch off the device.
2. Toggle the RAID switch on the device’s backside
to the desired RAID mode.
3. Press “Set” and power on the device
simultaneously.
4. The device will beep and the desired RAID
mode is set.
5.4 Remove defective RAID HDD
In case a HDD inside a RAID array gets defective,
the front LEDs for HDD activity will cease and the
device will beep until the “Set” button is pressed.
In a RAID 1, 3, 5 and 10 array the data can be
restored by rebuilding the array (see 5.5).