Rebuild – SHARKOON 2-Bay RAID Box User Manual

Page 6

2-BAY RAID BOX

In a RAID 1 the data can be restored by rebuilding the

array (see 7.).

Data from an existing RAID 0, Standard or Combined

mode are lost. Change the defective HDD.

7. Rebuild

Note:

1. The new HDD must provide at least the same

capacity as the replaced one.

2. Do not change the RAID mode prior to the

rebuilding.

3. Do not change the HDD order before commencing

the rebuild process.

4. The rebuild procedure may take very long for

bigger HDDs (> 1 TB), but the RAID Box may be

used meanwhile.

1. Switch off the device.

2. Change the defective HDD.

3. Power on the device, the rebuild procedure

will start automatically even when the device

is disconnected from your PC. During this

procedure the status LEDs will be flashing. As

soon as the LEDs for HDDs lights up blue, the

procedure is completed and the device may be

accessed.