AMX Kickstand for MVP Touch Panels MVP-KS - Manual (Page 8)

MVP-KS Kickstand
2 MVP-KS Kickstand for MVP Panels
Securing an MVP Panel to an MVP-KS
1. Place the MVP face down and locate the MVP-KS alignment guide pins (FIG. 1).
These pins are inserted into the respective MVP alignment guide insertion holes (located along the
underside of the MVP and at either sides of the connector strip).
2. Grasp both sides of the kickstand and insert the alignment guide pins into the insertion holes on the
bottom of the MVP (FIG. 1).
3. Maintain a kickstand connection to the bottom of the MVP panel (FIG. 2).
4. Press down on the AMX logo to insert the retractable latch into the opening (just above the MVP
metallic plate). Upon proper connection, you should hear a click when the latch grabs onto the
metallic plate.
5. Extend the MVP-KS support arm.
Removing an MVP Panel from an MVP-KS
1. Place the MVP panel face down, and pull upwards on the MVP latch release lever, located below
the kickstand’s AMX logo (FIG. 3).
2. Pull off the MVP-KS from the back of the MVP panel.
FIG. 2 Installing an MVP-KS
alignment pins
To avoid potential damage to the panel, make sure the kickstand is installed properly
before use.
FIG. 3 Releasing the MVP- from the MVP-KS
MVP latch release lever