RIKON Power Tools 23-400 - Manual (Page 9)

- to remove the workpiece from the machine, position yourself
offset to one side of the outfeed opening.
2. To thickness plane stock which surfaces are not parallel, use
suitable feeding aids (make fitting templates).
3. Set planing thickness.
4. Start motor.
5. Feed workpiece slowly and straight into the planer. It will then
be automatically fed through the planer.
6. Guide workpiece straight through the planer.
7. Switch machine off if no further cutting is to be done immedi-
ately afterwards.
5.3. FEED SPEED CHANGE
The feed speed of this machine can be adjusted by the handle (A,
Fig.9).
- Start the motor
- Turn the handle clockwise, the feed speed will be increased.
- Turn the handle counter-clockwise, the feed speed will de-
crease.
Note: The feed speed changing handle only can be operated
when the motor is running.
A
FIG. 8
FIG. 9
9