RIKON Power Tools 10-305 - Manual (Page 7)

2. UNPACKING AND CHECKING CONTENTS
The 10-305 10” Bandsaw is shipped complete in one box.
a. Separate all parts from carton and check each item with “Table of
Carton Contents” to make sure all items are accounted for, before
discarding any packing material.
b. Remove the protective oil that is applied to the table. Use any
ordinary house hold type grease and spot remover.
c. Apply a coat of paste wax to the table to prevent rust. Wipe all
parts thoroughly with a clean dry cloth.
ASSEMBLY
2. INITIAL ASSEMBLY
The machine is supplied partly assembled. Prior to use, the follow-
ing items have to be installed: Table, Blade Tension Knob and Rip
Fence.
WARNING: To Avoid injury, do not attempt to run or use this ma-
chine until all parts are assembled and working properly.
a. Assemble the upper table trunnion to the lower table trunion with
Carriage Bolt, Glide Piece, Washer and Wing Nut. Place the table
on to the upper table trunnion, taking care when passing the saw
blade through the slot of the table (See Fig. 1).
Locate four hex bolts and four lock washers from the bag of loose
parts. Mount the table to the upper table trunnion and install a bolt
with washer in each hole, then tighten with adjustable wrench.
A B
C
D
E F G
CARTON CONTENTS
Item Description Qty
A Main Machine...............................................................1
B Fence.............................................................1
C Table...................................................................1
D Guide Rail..................................................1
E Manual..............................................................1
F Upper Table Trunnion Assembly........................................1
G Bag of Loose Parts........................................................1
LIST OF LOOSE PARTS IN BAG
Item Description Qty
Blade Tension Knob.........................................1
Hex. Socket Head Cap Screw M6x30...............1
Washer 6.........................................................1
Wing Nut M6....................................................1
Hex. Bolt M6x12..............................................4
Lock Washer 6.................................................4
Star Knob Screw...............................................2
Washer 6 .........................................................2
M3 Hex “L” Wrench..........................................1
M5 Hex “L” Wrench...........................................1
7
1. TOOLS REQUIRED FOR ASSEMBLY
Item Description
Qty.
Medium Screwdriver..............................1
Adjustable Wrench.................................1
Square ...................................................1
10-305
www
.rikontools.com
10-305M4
10” W
oodworking Bandsaw
Operator
’s Manual
Record the serial number and date of purchase in your manual for future reference.
Serial Number: _________________________ Date of purchase: _________________________
For technical support or parts questions, email [email protected] or call toll free at (877)884-5167
4001824