Ragalta RDF-1220 - Manual (Page 4)

To Assemble
1. Remove the Base Nut from the bottom of the Fan Assembly by turning it counterclockwise.
2. Place the bottom of the Fan Assembly into the Base, and then replace the Base Nut.
3. Remove the Spinner and the Locking Nut from the Motor Shaft by turning them in the direction of the
arrow marked LOOSEN.
4. Align and place the Rear Guard, Handle on top, on the Motor Shaft and against
the Motor Housing (see Fig. 1).
5. Tighten the Locking Nut against the Rear Guard by turning it in the direction of
the arrow marked TIGHTEN.
6. Align and place the Fan Blades onto the Motor Shaft.
7. Tighten the Spinner onto the end of the Motor Shaft and against the Fan Blades
by turning it in the direction of the arrow marked TIGHTEN.
8. Open the Clamps on the Front Guard, and then connect the Rim Hook of the Front Guard
onto the uppermost prong of the Rear Guard (see Fig. 2).
9. Pull it down to snap the Rim Hook into place, and then close each Clamp over both Guards
to secure them (see Fig. 2).
To Use
CAUTION: Ensure the product is fully assembled before plugging it into an electrical outlet.
NOTICE: To avoid damaging the product, press only one Button at a time.
1. Place the assembled Fan on a flat, level, stable surface.
2. Ensure it is set to OFF, and then plug the Power Cord into a standard 120-volt AC electrical outlet.
3. To turn on, press the desired Speed Button: LOW, MED, or HIGH.
4. To adjust the Fan angle, tilt the Motor Housing up or down until it clicks into place where desired.
5. To start/stop oscillation, push/pull the Oscillation Knob, respectively.
6. To turn off, press the OFF Button, and then unplug the product from the electrical outlet.
WARNING: Always unplug the product from the outlet when not in use or if it will be left unattended.
User Servicing Instructions
WARNING: Always ensure the product is unplugged from the electrical outlet and allowed to cool before
servicing, relocating, cleaning, or storing it.

This product is permanently lubricated at the factory before shipping and will not require further
lubrication for the life of the product.
WARNING: Additional lubrication of motor parts could increase the risk of a fire hazard.