Kushlan Products 600 Movable Pedestal - Manual (Page 10)

Transporting the Mixer Operation 10
Disconnect the power cord. Hold the support
leg and dump handle and move as shown
below. Make sure there is no material in the
drum
Maintenance and Cleaning
Disconnect the power cord
1. Clean thoroughly after each use. Remove all material
from the mixer
2. Lightly grease all moving parts
3. Keep the motor cooling fins clean and free of build up.
4. When cleaning the mixer, wipe the On/Off switch
assembly and motor with a damp cloth. Do not spray
water directly onto this area. Protect motor and switch
assembly from rain.
When tilting the drum to pour
material, do so in a very smooth
manner. This keeps the mixer
balanced and upright.
1. Position the mixer on a level surface. (NOTE:
Maximum slope is 5 degrees. Before filling the
drum, make sure the mixer can empty into a wheel
barrow).
2. Use a 3 prong, grounded, 110V/120V power con-
nection. Although the minimum gauges are listed
below, we recommend that a 14 gauge(AWG) wire
be used for all lengths.
3. While the drum is rotating add water, material
and aggregate. Secure the stability bolt prior to
drum rotation.
4. To pour the material, elevate the dump handle
while the drum is rotating.
5. In the event of overheating and your motor shuts
down, turn off the On/Off switch and unplug the
unit for 15 minutes. After the cooling period, plug
in the unit and press the Manual Reset Thermal
Protector button, then the On/Off switch to on.
25 50 100 150
18 16 16 14
120
0-6
Cord Length
(total feet)
AWG
(wire gauge Bolts)
Volts
Amphere
Rating