Kushlan Products KPC160W User Manual

Page 6

CAUTION:

NEVER attempt to check the V-belt with the engine running. Severe injury can occur if your hand gets caught between

the V-belt and the clutch. Always use safety gloves.
Checking and Replacing the V-belt and Clutch

After 200 hours of operation, remove the upper belt cover to check the V-belt tension (Figure 2).Tension is proper if the

belt bends about 10mm when depressed strongly with finger between shafts. Loose or worn V-belts reduce power

transmission efficiency, cause weak compaction and reduces the life ofthe belt itself.

KPC160W PLATE COMPACTOR

Model

KPC160WH

KPC160WR

KPC160WL

KPC160WK

Engine

Air-cooled,single

cylinder,4-stroke

Engine Type

Petrol,Honda

Petrol,Robin

Petrol,Loncin

Diesel,Kipor170F

GX160

EY20

G160F

Power (hp)

5.5(4.0kw)

5.0(3.7kw)

5.5(4.0kw)

3.8(2.8kw)

Weight (kg)

84(185 lbs)

94(208 lbs)

Centrifugal

force

Frequency

(vpm)

5500(92Hz)

Compaction

depth

(cm)

30(12in)

Travel

speed

(cm/s)

23(9in/s)

Efficiency

(m2/hr)

405(4358

ft2/hr)

Plate

Size

(cm)

53Ч50(21Ч20in)

Dimension

(cm) 110Ч50Ч85(43Ч20Ч33in)

Optional

with water tank, additional weight 6 kgs

Drive Belt: 1×”B” section vee belt
Acoustic Noise ( According to 2000/14/EC)

Model No.

KPC160W

Measured Sound Power Level

101.5dB

Guaranteed sound power level

104.50dB

Uncetainly

3dB

Hand-Arm-Vibration ( as per ISO8662, part 1, m/s2):4-9

CAUTION:

Whenever the compactor's vibration becomes weak or lost during normal opera-

tion regardless of operation hours, check the V-belt and clutch immediately.

Replacing the V-belt

Remove the upper and lower belt covers, Engage an offset wrench (13mm) or the

like to vibrator pulley (Lower)fastening bolt. Engage waste cloth or the like at mid-

way of V-belt on the left side and while pulling it back strongly, rotate the offset

wrench clockwise so that the V-belt will come off.

Reinstalling the V-belt

Engage V-belt to the lower vibrator pulley and push the V-belt to the left side of upper clutch and, in the same manner

as in removal, rotate offset wrench clockwise so that the V-belt goes back on.

Checking Clutch

Check the clutch simultaneously with V-belt checking. With belt removed, check outer drum of the clutch for seizure

and "V' groove for wear or damage with your eyes. Clean the "V" groove as necessary. Wear of lining or shoe should be

checked with running check. If the shoe is worn, power transmission becomes deficient and slipping will result.