Kushlan Products 350DD Epoxy - Manual (Page 7)

Assembly Instructions
7
Step 1 - Remove each wheel and face long
end out. Thread axle through axle spacer
which is between the wheels
Step 2 - Attach washer with R clip,
securing through hole on axle.
Step 3 - Remove outer nuts, lock-washers
& flat washers from the 4 studs on the
motor gearbox assembly. Check inner
nuts to make sure they are tight. (about
20ft. lbs of torque)
Step 4 - Install motor gearbox on back of
mixer frame with flat washers, lock
washers and nuts to all 4 studs.
Step 5 - Put bolt through hole
Step 6 - Install motor cover with 5/16”
x1/2” whizlock screws & nuts
Step 7 - Slide handles in place, secure
with lock pins / lanyards and install grips
How to Mix Concrete
1. You will need approx. 2 1/2 gallons of water.
2. 2-80 lb bags of premix concrete
3. Start Mixer in motion
4. Add 2 gallons of water
5. Add 1-80 lb bag of premix concrete
NOTE: Mixture will be very sloppy
6. Slowly add 2nd bag of concrete.
7. Add 1/2 gallon of water slowly to obtain desired thickness.
How to Mix Sand & Gravel
1. Use a 8 1/2 X 12” square shovel
2. Portland cement, gravel or round stone and masonry sand.
3. Start mixer in motion.
4. Put in 2 gallons of water.
5. Add 6 shovels full of gravel or round stone.
6. Add 2 shovels full of Portland cement.
7. Slowly add 4 shovels full masonry sand.