Johnson Level & Tool Mfg. 40-6264 User Manual
Page 2
Turn in the counterclockwise direction to turn the unit off. When the laser
fails to power up, the batteries will need to be replaced. To replace the
batteries, unscrew the switch cap completely, remove the old batteries
and inspect the interior of the battery compartment for signs of dirt,
moisture or leakage from the batteries. Correct any problems with acid
leakage or case sealing before installing new batteries. Replace the
batteries in fresh air ONLY. When replacing the batteries, the negative
end goes into the laser first. All positive ends must point towards the
switch cap. All batteries must be replaced at the same time. Do not
attempt to reuse batteries or mix batteries of different manufacturers or
types. Other than the batteries, there are no user serviceable parts on
the laser. This product is warranted for a period of one year from the date
of purchase for manufacturing defects. The manufacturer reserves the
right to repair or replace this product if it fails due to manufacturing
defects during the warranty period. Abuse, neglect or disassembly of
the laser voids this warranty. Like any other tool, the service that this
product will provide is dependent on the care it receives. Please return it
to your nearest Mine Supply Dealer for service and repair.
Model L56 MSHA
L56 Alignment Laser complete with
2 AAA Alkaline Batteries .
Model CL2000 Optional Cylindrical Lens Line Generator
Used
with
L56
Alignment
Laser.
Projects
a
10
foot
line from a distance of
100
feet.
Model 10LD Optional 10 mw Laser Diode System
Used with CL2000 Line Generator. Increases
Laser Beam Brightness by a factor of 3.
Model AP30 Optional Soft Carrying Case 12” Long, Plush
Lined and Padded with Full Length Zipper.
AP354S
Stainless Steel Tabs with Slots for Spad
Mounting
Pointed Thumb Screws 1 Pair of Stainless Steel Thumbscrews that
replace
adjustable
set
screws.
Manufactured by: Laser Tools Co., Inc., 12101 Arch St.
Little Rock, AR 72206, Phone 501-562-0900
FAX
501-562-0022
E mail
Web
site:
http://www.Lasertoolsco.com