Johnson Level & Tool Mfg. 40-6266 User Manual
Page 2
some other means of sturdy roof support. Bailing wire, chain, rope or other means of
suspension can be used to hang the laser and provide a means of adjusting for
elevation. This laser has sufficient mass to help prevent it from swaying in entries with
high airflow. The end cap is turned in the clockwise direction until the laser is powered.
Do not over tighten. Turn in the counterclockwise direction to turn the unit off. When
the laser fails to power up, the batteries will need to be replaced. To replace the
batteries, unscrew the switch cap completely, remove the old batteries and inspect the
interior of the battery compartment for signs of dirt, moisture or leakage from the
batteries. Correct any problems with acid leakage or case sealing before installing new
batteries. Replace the batteries in fresh air ONLY. When replacing the batteries, the
negative end goes into the laser first. All positive ends must point towards the switch
cap. All batteries must be replaced at the same time. Do not attempt to reuse batteries
or mix batteries of different manufacturers or types. Other than the batteries, there are
no user serviceable parts on the laser. This product is warranted for a period of one
year from the date of purchase for manufacturing defects. The manufacturer reserves
the right to repair or replace this product if it fails due to manufacturing defects during
the warranty period. Abuse, neglect or disassembly of the laser voids this
warranty. Like any other tool, the service that this product will provide is dependent on
the care it receives. Please return it to your nearest Mine Supply Dealer for service
and repair.
Model GL56 MSHA GL56 Alignment Laser complete with 2 AAA Alkaline
Batteries .
Model GL2000 Optional Cylindrical Lens Line Generator Used with GL56
Alignment Laser. Projects a 10 foot line from a distance of
100
feet.
Model AP30 Optional Soft Carrying Case 12” Long, Plush Lined and
Padded with Full Length Zipper.
AP354S
Stainless Steel Tabs with Slots for Spad Mounting
Pointed Thumb Screws 1 Pair of Stainless Steel Thumbscrews that replace
adjustable set screws.
Manufactured by: Laser Tools Co., Inc., 12101 Arch St.
Little Rock, AR 72206, Phone 501-562-0900
FAX 501-562-0022 e mail
Web
site:
http://www.Lasertoolsco.com