Alto-Shaam Combinaton Oven/Steamer CT Express 4.10ESiVH - Manual (Page 19)

CT ExpRESS INSTALLATION MANUAL • 17 .
indicator light
if the indicator light does not
illuminate, the filters may be
missing or not properly aligned.
check them for proper positioning.
Ventless hood and oven will not
operate unless the hood is closed
properly.
i n s t a l l a t i o n
v e n t l e s s h o o d m o d e l
The Ventless hood option is factory installed
directly on the top of the alto-shaam combitherm
oven. The hood is designed to vent clean air back
into the kitchen, filtering vapors and grease. a
high-power fan draws steam and fumes into the
hood intake and out the top surface exhaust vent.
Fumes and vapors are circulated through filters.
an activated charcoal filter cleans the air before
venting it out the top of the hood.
filter door latch
using a coin or screwdriver,
turn to open; reverse procedure
to close and latch.
hood and oven will not operate
unless this is closed properly.
operation
1
Turn the ventless hood power knob “ON”.
2 indicator light will illuminate.
3
Wait five seconds, then press the combitherm
oven power “ON”.
2
1
Timed Latching Mechanism: in
order to evacuate steam and grease-
laden air from the oven interior, this
mechanism prevents the operator
from fully opening the oven door for
20 seconds. longer wait times can
be programmed into the control. The
mechanism automatically disengages
at the end of a pre-set time allowing
full door extension.
Emergency Latch Release: This
release is to be used only if
the timed latch mechanism is
not working or in the event of a
power outage. repeated use of the
emergency release may damage
the switching mechanism. latch is
located on the right side of the oven,
toward the back.
3