AEG A72900GNX0 - Manual (Page 20)

5. Unscrew the hinge (B1) and remove the
cover plate (B2) and the support (B3).
Remove the cover (B4) on the opposite
side and install the support (B3) the
cover plate (B2) and the hinge (B1). In-
stall the cover (B4) on the opposite side.
6. Unscrew the lower hinge (C1). Move the
pin to the opposite side (C2). Unscrew
and move the pedal to the opposite side
(C3).
Screw on the lower hinge on the oppo-
site side.
7. Tighten the pin with the adjustment
spanner supplied.
8. Install the handle on the opposite side.
9. Raise the appliance and install the ven-
tilation grille.
10. Put the cabinet in position.
WARNING!
Reposition, level the appliance, wait for at least four hours and then connect it to the pow-
er socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of the gasket.
NOISES
There are some sounds during normal running (compressor, refrigerant circulation).
B1
B3 B4
B2
C2
C3
C1
20 Noises