FallTech Contractor Series SRL’s - Manual (Page 6)

11
Figure 2.1: Clear-Fall Diagram
2.10: Swing-Fall
Swing-Fall is the phenomenon that occurs when the user falls from a
location that is not directly adjacent to, or directly below the anchorage
connector. This is also referred to as the “pendulum effect”, and can
result in a situation where the user is not only falling vertically, but is also
swinging on the horizontal as well. This can bring additional hazards into
play, as you may swing into an obstruction or structural element, causing
serious injuries (see figure 2.2). A significant Swing-Fall may also
require increased Clear-Fall distance. As a rule of thumb, you should
ensure work in an area that does not exceed an angle greater than 15
degrees in any direction from your anchorage.
Figure 2.2: Swing-Fall Diagram
12
Be sure to consider Swing-Fall when calculating your Clear-Fall
requirements and checking the fall path for hazards and instructions.
Failure to do so may result in serious injury or death. Should you have
any questions regarding Free-Fall, Clear-Fall, Swing-Fall or other
hazards in the fall path, be sure to contact FallTech or consult with a
competent person or your direct supervisor on your job-site.
Section 3: Use and Limitations
This section deals with the general use and limitations of the FallTech
Contractor Series SRL’s. Please read this section and all sections of the
manual thoroughly. If your application is not addressed, or if you have
questions regarding your specific needs, please contact FallTech
immediately for additional guidance.
3.1: General Guidelines
When properly installed and utilized, this FallTech Contractor SRL will
provide safety and mobility for a single user. As the user moves, the
SRL will pay out and retract automatically. In the event of a fall, a