Elitegroup MS110 (V1.0) - Manual (Page 20)

13
Using BIOS
1st/2nd/3rd Boot Device (Hard Drive/CD/DVD/Removable Dev./LAN)
Use this item to determine the device order the computer used to look for an
operating system to load at start-up time. The devices showed here will be different
depending on the exact devices installed on your motherboard.
CMOS Setup Utility - Copyright (C) 1985-2010, American Megatrends, Inc.
Hard Disk Driver Priority
Hard Disk Driver
1st Drive SATA: MAXTOR STM316
Help Item
Specifies the boot
sequence from the
available devices.
fHard Disk Drive Priority (Press Enter)
Scroll to this item and press to view the following screen:
Press to return to the Advanced BIOS Features page.
Boot Up Numlock Status (On)
This item defines if the keyboard Num Lock key is active when your system is
started.
APIC Mode (Enabled)
This item allows you to enable or disable the APIC (Advanced Programmable Inter-
rupt Controller) mode. APIC provides symmetric multi-processing (SMP) for sys-
tems, allowing support for up to 60 processors.
: Move F10: Save and Exit +/-/: Value Enter : Select
F9: Optimized Defaults F1:General Help
mnlk
ESC:Exit Wothout Saving
CMOS Setup Utility - Copyright (C) 1985-2010, American Megatrends, Inc.
Optical Disk Driver Priority
Optical Disk Driver
1st Drive CD&DVD: SIimtype DV
Help Item
Specifies the boot
sequence from the
available devices.
f Optical Disk Driver Priority (Press Enter)
Scroll to this item and press to view the following screen:
Press to return to the Advanced BIOS Features page.
: Move F10: Save and Exit +/-/: Value Enter : Select
F9: Optimized Defaults F1:General Help
mnlk
ESC:Exit Wothout Saving