Elitegroup L51AI v.5 - Manual (Page 15)

■ chapter 5 trouble shooting
5-15
Firewire (IEEE1394) and USB2.0 Problems
The USB device does not work -
„
Windows NT 4.0 does not support USB protocols
„
Check the settings in the Windows Control Panel.
„
Make sure you have installed the necessary device
drivers.
„
Contact the device vendor for additional support.
The IEEE1394 port does not work -
„
Go to [Start > Settings > Control Panel > System >
Hardware > Device Manager]. You should see an entry which
reads “OHCI Compliant IEEE 1394 Host Controllers”. If it does
not exist, Windows has not detected the host controller or the
device driver has not been installed properly. If there is a yellow
mark or red-cross on the 1394 host controller, it may be a
device or resource conflict. Replace or update the device driver
from the factory CD-ROM disk or consult Windows manual on
how to solve the resource conflict problem.
„
Make sure the cable is fully connected.
„
Make sure you have installed the necessary device
drivers.
„
Contact the device vendor for additional support.