Audiovox PVS21090 - Manual (Page 16)

E
15
TV CHANNEL SETTING
1. Press the TV MENU button.
2. Use the or button to select TV CHANNEL
SETTING.
3. Use the or button to select the options
(Antenna / Auto Scan / Auto Scan Add CH
/ Channel Skip / Channel No. / Channel
Label).
4. Use the or button to make adjustment.
The screen will change to your selected mode
immediately. Press the TV MENU button to
return to the previous menu.
5. Repeat steps 2 to 4 to adjust other options.
6. To exit the TV SETUP MENU and return to
the normal screen, press the EXIT button on
the remote control.
NOTE
Channel No. : 2-69 Channel for Air, 1-135
Channel for CATV.
TV SETUP
Channel Label: You may edit one label for each channel.
1. Select the Channel Label item and press the or button to go
into the channel label edit screen.
2. Use the or button to enter the number or letter.
3. Use the or button to move and edit for the next character.
4. After editting, press the DISPLAY button and the Channel &
Channel Label will be shown on the screen.
Antenna : Select “CATV” to receive cable signal. Select
“AIR” to receive air singal.
Auto Scan : Automatically search all channels for those
with adequate signal strength.
Auto Scan Add CH :The stored channels can not be cleared and
the Auto Scan Channels will be added.
Auto Scan Add CH
Channel Skip
Channel No.
Channel Label
UP/DOWN ADJUST “MENU”:EXIT
Antenna
Auto Scan
Air
If you has selected CATV in TV CHANNEL
SETTING, then you can select Cable System
(AUTO / STD / HRC / IRC) in the sub menu
as the picture shown.
Cable System
Start to Scan
Auto
UP/DOWN ADJUST “MENU”:EXIT
EDIT SELECT “MENU”:EXIT
1 2 3 #
Channel Skip: You may switch ON/OFF the skip function of
each stored channel by selecting the channel
with
/ button (and using / button to
select page if the amount of stored channels in
more than 1 page), and followed with pressing
the ENTER button.
“ENTER”:SELECT
No. Skip Program Name
2.0 Off
“MENU”:EXIT
3.0 Off