Elitegroup 223EI v.8 - Manual (Page 3)

■ appendix C Using Power Cinema
C-3
2. Installation.
2-1 Before installing Linux system, please make sure you have
a "4th partition" on the HDD and it should be 500MB. If not,
please create a new one.
2-2 Insert the PCM4 Linux installation disc into the optical drive
and reboot the system.
2-3 When system finished booting from the optical drive, you
should see a warning message. Read it carefully.
2-4 In the step above, follow the on-screen instruction. When
prompted, type "YES", and then press the "Enter" key. It
will take about 2-3 minutes to install the software.
2-5 When installation is finish, please type "poweroff" and
press the "Enter" key to shutdown system. Press the P
button to start Power Cinema.
Note: If you made a mistake in the steps above, (for example, you didn't type
"YES" in the 4th step), the system will exit to a Linux shell. If you still want to
install PCM Linux, you can continue the installation by typing "install.sh" in the
command prompt and you will return to step 2-3 as above.