Antec NEOLINKTM P190 - Manual (Page 6)

5
noise-dampening ability of the rubber grommets. Always mount the HDD with
the thicker side of the silicone grommets facing up.
5. Repeat the same procedure for other devices as necessary.
6.
Connect 4-pin molex or SATA power connectors on the power supply to the
power connectors on each of the devices.
7. Slide the cage back to the case and fasten the thumbscrew.
External 3.5” Drive Installation
There is one external 3.5” drive bay.
1.
Carefully remove the plastic drive bay cover and metal plate covering the
drive bay.
2. Find a pair of 3.5”drive rails from the box containing the top fan spoiler.
3.
Mount the drive rails onto the sides of the 3.5” device. Make sure the metal
portion is angled on the outside and facing forward.
4. Slide the device into the drive bay until it clicks into position.
5.
Connect a small 4-pin connector from the power supply to the 4-pin connector
on the floppy drive.
5.25” Device Installation
There are four 5.25” drive bays that require a total of eight drive rails.
1.
Carefully remove the plastic drive bay cover and the metal plate covering the
drive bay.
2. Mount the drive rails onto the sides of the 5.25” device. Make sure the metal
portion is angled on the outside and facing forward.
3. Slide the device into the drive bay until it clicks into position.
4. Mount other devices accordingly.
5.
Connect 4-pin molex connectors from the power supply to the 4-pin connector
on each of the devices.
PCI-Express Add-in Card Holder
There are two PCI-E card holders for the newest dual graphic card systems in the
tool bag. An instruction sheet on how to install them is included as well.
The Snake Light
A white LED snake light is included to illuminate the inside of your case and
features a flexible neck that can be adjusted to any desired position. To turn it on,
simply connect it to a molex connector or the internal USB connector while the
system is in standby mode (i.e., the computer is off but with the power supplies
are plugged in to the AC outlet).
Note: The Snake Light comes with both the 4-pin molex or the internal USB
connectors. Please do not connect the light to both connectors the same time.
Cooling System
The TriCool™ fan:
The case includes four installed 120mm TriCool™ fans. The three-speed fans let
you choose between quiet performance or maximum cooling (see specifications
below). Note: The minimum voltage to start the fan is 5V. We recommend our
users to set the fan speed to High if you choose to connect the fan to a fan control
device. A fan-controller regulates the fan speed by varying the voltage to it. The
voltage may start as low as 4.5V to 5V. Connecting a TriCool™ set on Medium