Elitegroup G733 - Manual (Page 65)

time, your CMOS battery may be depleted. Contact your dealer to change the
battery.
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
Problem:
The message: “Invalid system disk, Replace the disk, and then press any
key” appears during boot.
Check and make sure that you do not have a non-bootable floppy diskette
inserted in your floppy drive. If your USB FDD is empty, you may not have an
operating system installed on your drive. Contact technical support for
assistance.
You hear irregular beeps during operation of the Notebook and the
system halts.
The problem is beyond the scope of this manual. Contact technical support.
An unidentified message is displayed.
Reboot the computer and run the BIOS system setup. Confirm the Setup
parameters. If the same message is displayed after booting up again, contact
technical support for assistance.
The system cannot access the DVD-ROM drive.
Check that a CD is properly inserted in the drive. Make sure that you are using
the correct program for that kind of CD. For example, the system cannot read
a data CD using an audio program.
You cannot operate the printer.
Check the printer cable connection. Ensure that the printer power switch is
turned on. Confirm that the printer is on-line.
You can’t save data to disk.
Ensure that the disk has been formatted.
Consult your operating system manual for information on formatting floppy
diskettes.
The diskette is write-protected.
Eject the diskette, remove the write protection, and try again.
The diskette if full.
57