Elitegroup X72IA v.4 - Manual (Page 12)

■ ■ ■ ■
chapter 4 upgrading your computer
4-12
Installing a Mini-Card into the System
To install a new Mini-card, do the following:
1. Follow steps in the previous section, Installing a memory
module (DIMM) into the system, to access the Mini-Card
Socket.
2. The mini-card will only fit in one direction. Align the small
notch in the module with the socket on the connector and insert
the card at an angle of approximately 30 degrees into the
empty socket. Then press it firmly so that the contact edge is
driven into the receiving socket. Pivot the mini-card and fasten
2 Screw-E’s to hold the card down.
Note:
If you want to remove a mini-card from the socket, remove 2 Screw-E’s.