beautypg.com

Your dishwasher has arrived, Installation and moving, Ishwasher – Ariston AFA 370 User Manual

Page 10

background image

8

ARISTON DISHWASHER - Instructions for installation and use

D

ISHWASHER

Installation and moving

After having bought or moved your dishwasher to another home, a

correct installation ensures that your dishwasher will operate

smoothly and efficiently.

blocked and damage the appliance.

Hot water connection.

Your dishwasher can be supplied

with hot water from the mains

supply (if you have a central heating

system with radiators) at a tempe-

rature of no more than 60°C.

In this case, the wash cycle time

will be about 15 minutes shorter

and the wash will be slightly less

effective.

The connection must be made to

hot water supply following the

same procedures as those indicated

for the cold water connection.

Drain hose connection

Fit the drain pipe into a drain line

with a minimum diameter of 4 cm

or place it over the sink. Avoid

restricting or bending it. Use the

special plastic elbow provided (see

figure) to position it in the best

possible way. The part of the pipe

marked with the letter A should be

between 40 and 100 cm above the

ground.

The pipe should not be immersed

in water.

Electrical connection.

First of all, check that the mains

voltage and frequency values

correspond to those stated on the

rating plate located on the stainless

steel inner door of the appliance

and that the electrical system to

which the dishwasher is connected

is sized for the maximum current

indicated on said rating plate.

Earth: indispensable

safety.

Only now can you plug the

appliance into a socket provided

with an efficient earth connection

(the system's earthing is a

guarantee of safety provided for

by law, make sure your system

has it).

Power supply wire.

Check the power supply wire on a

regular basis; if it is damaged, we

recommend you have it replaced

by an authorised technical

Assistance service centre.

The plug

The dishwasher plug must be

accessible, so that maintenance

can be done safely.

Choose where you want to install

your dishwasher, you can even

place it so that its sides or back

panel are side by side with furniture

or up against the wall. The

dishwasher is provided with water

supply and drain hoses, which can

be directed towards the left or right

to facilitate appropriate

installation.

This dishwasher model can be built

under a single worktop (please read

the relevant instruction sheet).

Levelling.

Once the appliance is

positioned, adjust the feet by

screwing them in or out

depending on how high you

want it and to level it so that it

is horizontal. Make sure that it

is not inclined more than 2

degrees. If the appliance is

level, it will help ensure its

correct operation.

Cold water connection.

This electric household

appliance should be connected

to the water mains using the

cold water supply hose

provided with the appliance

only. Do not use a different

hose. In the event of replacements,

use original spare parts only.

Connect the cold water supply

hose to a 3/4 gas.

If the water pipes are new or have

not been used for an extended

period of time, let the water run to

make sure that the water is clear

and free of impurities. If this

precaution is not taken, there is a

risk that the water inlet can get

Your dishwasher has arrived

A

If the power

socket to which

the appliance is

connected is not

compatible with

the plug, replace

it with a suitable

plug rather than

using adapters or

multiple plugs as

these could cause

overheating or

burns.

If the power

socket to which

the appliance is

connected is not

compatible with

the plug, replace

it with a suitable

plug rather than

using adapters or

multiple plugs as

these could cause

overheating or

burns.