Elitegroup U40-50SA - Manual (Page 31)

23
• Low power consumption
• 12.7mm height
Precautions for Handling CD Discs
• Always hold the disc by the edges, avoid touching the surface.
• Use a clean, dry, cloth to remove dust, smudges, or fingerprints.
Wipe from the center outward.
• Do not write or place objects on the surface of the disc.
• Store discs in a cool dry place not to damage the disc.
• Do not use benzene, thinners, or cleaners with detergent. Only
use CD-ROM/DVD-ROM/Combo cleaning kits.
• Do not bend or drop the discs.
Loading a Disc
To play a CD disc, follow the instructions listed below.
1. Push the DVD Dual/SuperMulti eject button on the CD drive
door. Gently pull the tray all the way out.
2. Carefully lift the CD disc by the edges and make sure the
shiny surface is face down (the side with no writing on it).
Carefully insert the CD disc onto the tray. Push the CD disc
down gently so that it snaps onto the center ring.
3.
Push the tray back into the drive.
To remove a CD disc, do the following:
1.
Check the LED display and make sure that the computer is not
accessing the DVD Dual/SuperMulti.
2. Push the eject button and pull the tray all the way out.
3.
Carefully pick up the CD disc by the edges and – while
pressing down on the center ring – remove the CD disc from
the tray.
Do not insert any foreign objects into the
disc tray. If you experience difficulty when ejecting the CD
disc tray, stretch a paper clip (or use a pin or a thin metal rod)
and insert it into the emergency eject hole located on the right
side of the front panel. The CD disk tray should eject
immediately. This procedure can also be used to remove a
CD from the drive when the Notebook is powered off.