ReadyLIFT Honda Pilot, 2003-2008, 2WD & 4WD, 2.0F/1.0"R" - Manual (Page 5)

ReadyLift
®
(Part# 69-8010)
2003-2008 Honda Pilot FWD/4WD Installation Instructions
2”Front/2” Rear
Revised
5-6-09
ReadyLift Suspension, Inc.
3201 W. MacArthur Blvd, Santa Ana, CA, 92704
T o l l F r e e ( 8 8 8 ) 9 2 2 - 2 2 9 4 Fa x 7 1 4 -8 6 2 -2 9 7 2
Please read instructions thoroughly and completely before beginning installation.
Check www.Readylift.com for any installation instruction updates
Installation by a trained mechanic is recommended.
17. 18.
Support the lower control arm with a jack. Remove the
rear upper shock mounting bolt.
19.
20.
Remove the bolt on the body end of the arm and remove
the stock arm. Make sure that both ends of the EZ Arm
have equal thread showing on both sides of the turnbuckle.
Adjust the EZ Arm to the same length as the stock arm. Install
the arm by first installing the bolt at the body, but DO NOT
TIGHTEN. Install the ball joint end into the knuckle using the
OEM nut and cotter pin.
21. 22.
Remove the bolt that connects the lower control arm to
the knuckle.
Remove the nut and cotter pin from the outer ball joint
end of the upper arm and break the taper using a tie rod
end separator.
Lower the jack then remove the coil. Be sure to mark
where the spring seat is on the lower control arm. You
may need to loosen the cam bolt at the frame.