Nilfisk-ALTO ATTIX 590-21 - Manual (Page 10)

4
1) Option depending on model
english
ATTIX 3 / 5 / 7 / 12 GALLON / 19 GALLON
5 1) Option depending on model
english
ATTIX 3 / 5 / 7 / 12 GALLON / 19 GALLON
Use only the brushes supplied
with the vacuum cleaner or
specified in the operating manu-
al. The use of other brushes can
adversely affect safety. Use only original Alto accesso-
ries and spare parts (see sec-
tion 9.5). The use of other parts
can adversely affect safety. Accessories and spare parts
2 Description
2.1 Purpose When used properly, the
industrial vacuum cleaners
described in these instructions are suitable for sucking up dry,
non-flammable, non-hazardous
dusts and liquids.
2.2 Operating elements See fold-out page at front of
these operating instructions.
1 Handle
2 Suction pipe support
3 Accessory holder
4 Applicance switch with suc-
tion power control 1)
5 Retaining clamp
6 Dirt tank
7 Grip to empty tank
1)
8 Inlet fitting
9 Appliance socket
1)
10 Cable hook
11 Operating knob for filter
cleaning 1)
12 Connection for compressed
air supply 1)
13 Connection for pneumatic
tool 1)
14 Tank locks 1)
15 Castor with brake
3 Before starting
3.1 Assembling the
vacuum cleaner
1. The mains plug should not yet
be inserted into a socket.
2. Open the retaining clamps (1)
and remove upper section of
the cleaner.
3. Take the accessories 1) out of
the dirt tank and the packag-
ing.
4. Place a filter bag into the tank
as described in the instruc-
tions (printed on the filter
bag).
IMPORTANT!
Press the filter bag connection
firmly on to the inlet fitting.
5. Fit the upper section of the
cleaner (do not damage the
filter bag) and close the re-
taining clamps.
NOTE!
Ensure that the retaining
clamps fit properly.
6. Fit the suction tube fastener 1)
about 20 cm from the edge of
the lower extension tube as
shown in the figure.
1
On delivery some of the accesso-
ries are lying in the tank and must
be removed before the vacuum
cleaner is used for the first time.
Remove the upper section of the
vacuum cleaner: The mains plug
should not yet be inserted into a
socket.