ReadyLIFT Ford Expedition SST Lift Kit: 2003-2014, 2WD & 4WD, 3.0F/2.0"R" - Manual (Page 3)

ReadyLift
®
(Part# 69-2070) 2008-2009 Ford Expedition 2WD & 4WD
3” Front Lift kit Installation Instructions
Revised
3-4-09
ReadyLift Suspension, Inc.
3201 W. MacArthur Blvd, Santa Ana, CA, 92704
T o l l F r e e ( 8 8 8 ) 9 2 2 - 2 2 9 4 Fa x 7 1 4 -8 6 2 -2 9 7 2
3
7) Install the lower strut mounting bolt, do not
tighten.
Use a jack to raise the lower control arm back into the
frame pocket.
8) Make sure the upper sway bar end link gets rein-
stalled at this time. Torque to factory specs.
9) Install the two lower control arm bolts but do
not tighten.
10) Tighten the upper ball joint. Torque to factory
specs. Tighten the three upper strut mounting
nuts, reinstall the tie rod end, and tighten the lower
strut mounting nut. Install the two 10mm brakeline
support bolts. Install ABS line back into the brake
line support.
Repeat steps 1-9 on opposite side.
After kit is installed reinstall the front wheels and
set vehicle on the ground.