ReadyLIFT Ford F250 Super Duty SST Lift Kit: 1999-2004, 4WD Only - 2.0F/2.0"R" - Manual (Page 2)

ReadyLift
®
(Part# 69-2085)
1999-2004 Ford F-250 4WD Lift Kit
Installation Instructions
Revised
6/3/2010
ReadyLift Suspension, Inc.
3201 W. MacArthur Blvd, Santa Ana, CA, 92704
Tol l Fre e (8 8 8 )9 2 2 - 2 2 9 4 F ax 7 1 4 - 86 2 - 2 9 72
Please read instructions thoroughly and completely before beginning installation.
Check www.Readylift.com for any updated installation instruction.
Installation by a trained mechanic is recommended.
Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground.
Use a minimum 3 ton jack stands and place under frame for safety or a (2) two post lift if available.
Make sure that the emergency brake is on and the rear wheels are blocked to prevent a rollout.
QTY
2
2
2
8
8
2
1
1
2
1
1
4
2
Description
FRONT SUSPENSION
Mini Leaf Pack
9/16-18x3x10 Semi Round U-bolts
9/16-18x3x11 Semi Round U-bolts
9/16-18 Barrel Nuts
9/16 Flat Washers
TRACK BAR CAM KIT for vehicles produced 4/01/99 and later.
Offset Cam Tube
.460” Thick Hex Cam
.390” Thick Hex Cam
.230” Thick Hex Cam
9/16-18x3.5” F911 Hex Head Bolt
9/16-18x4” F911 Hex Head Bolt
9/16 Hardened Flat Washers
9/16-18 F911 Stover Nut
Support the front axle with a hydraulic jack. Starting on the
driver side, unbolt the lower shock from the mount using a
21mm socket wrench.
Remove the u-bolt nuts and u-bolts.
2. 1.
Bill of Materials