ReadyLIFT Nissan Armada 2004-2007, 2WD & 4WD - 2.0 - T6 Billet" - Manual (Page 2)

Bolt Size
Millimeters
Torque Specs in FT/LB
Metric Grade
8.8
Metric Grade
10.9
6mm 6 8
8mm 16 22
10mm 40 45
12mm 54 70
14mm 89 117
16mm 132 175
18mm 182 236
Bolt Size
SAE
Torque Specs in FT/LB
Grade 5
Grade
8
5/16 15 20
3/8 30 35
7/16 45 60
1/2 65 90
9/16 95 130
5/8 135 175
3/4 185 280
Please read Instructions thoroughly and completely before beginning installation.
Installation by a certified mechanic is recommended.
ReadyLIFT Suspension Inc. is NOT responsible for any damage or failure resulting from improper installation .
Safety Warning: Suspension systems or components that enhance the on and off-road performance of your vehicle
may cause it to handle differently than it did from the factory. Extreme care must be used to prevent loss of control or
vehicle rollover during abrupt maneuvers. Always operate your vehicle at reduced speeds to ensure your ability to con-
trol your vehicle under all driving conditions. Failure to drive safely may result in serious injury or death to driver and
passengers. Driver and passengers must ALWAYS wear your seat belts, avoid quick sharp turns and other sudden ma-
neuvers. ReadyLIFT Suspension Inc. does not recommend the combined use of suspension lifts, body lifts, or other
lifting devices. You should never operate your vehicle under the influence of alcohol or drugs. Constant maintenance is
required to keep your vehicle safe. Thoroughly inspect your vehicle before and after every off-road use.
Installation Warning: All steps and procedures described in these instructions were performed while the vehicle was
properly supported on a two post vehicle lift with safety jacks. Use caution during all disassembly and assembly steps
to insure suspension components are not over extended causing damage to any vehicle components and parts included
in this kit. Included instructions are guidelines only for recommended procedures and are not meant to be definitive.
Installer is responsible to insure a safe and controllable vehicle after performing modifications.
ReadyLIFT Suspension Inc. recommends the use of an OE Service Manual for model/year of vehicle when disassembly
and assembly of factory and related components. Unless otherwise specified, tighten all bolts and fasteners to standard
torque specifications listed within the OE Service Manual, or as referenced in the torque specification list provided in
these instructions.
Suspension components that use rubber or urethane bushings should be tightened with the vehicle at normal ride
height. This will prevent premature wear or failure of the bushing and maintain ride comfort. Larger tire and wheel
combinations may increase leverage on suspension, steering, and related components. Due to payload options and ini-
tial ride height variances, the amount of lift is a base figure. Final ride height dimensions may vary in accordance to
original vehicle ride height. Always measure the vehicle ride height prior to beginning installation.
Vehicle ride height chart
Driver Front:
Stock height
Lift installed
Driver Rear:
Stock height
Lift installed
Pass. Front:
Stock height
Lift installed
Pass. Rear:
Stock height
Lift installed