NcSTAR TAR - Manual (Page 8)

BORE CLEANING CABLE AND BRUSH
This tool is designed to clean the bore of your rifle. Begin the take down
procedure according to the manufacturer’s instructions. Next, remove the
bore cable from the side pouch. Next, unscrew the bore brush from the
threaded rod attached to the tool. Extend this rod until it locks into place.
Close the tool handle and attach the cable to the threaded rod securely. Use
a bore guide to prevent damage to the breach and chamber surfaces. Run the
cable down the barrel from the breach to the muzzle and attach the patch tip
to the end. Pull a few solvent soaked patches through the barrel using this
method. Remove the patch tip, and run the cable down the barrel from the
breach again. Attach the solvent soaked bore brush and pull through as
many times as needed in order to loosen fouling build-up. Run dry patches
through to remove fouling. Repeat this process as many times as necessary
until the dry patches come out clean.
(7)