Avenview RSUN Series RSUN-17 - Manual (Page 5)

www.avenview.com 5
1.2 Safety Instructions
 Unplug equipment before cleaning. Don’t use liquid or spray detergent; use a moist cloth.
 Keep equipment away from excessive humidity and heat. Preferably, keep it in an air-conditioned
environment with temperatures not exceeding 40° C (104° F).

When installing, place the equipment on a sturdy, level surface to prevent it from accidentally falling
and causing damage to other equipment or injury to persons nearby.
 When the drawer is in an open position, do not cover, block or in any way obstruct the gap between
it and the power supply. Proper air convection is necessary to keep it from overheating.
 Arrange the equipment’s power cord in such a way that others won’t trip or fall over it.
 If you are using a power cord that didn’t ship with the equipment, ensure that it is rated for the
voltage and current labelled on the equipment’s electrical ratings label. The voltage rating on the
cord should be higher than the one listed on the equipment’s ratings label.
 Observe all precautions and warnings attached to the equipment.
 If you don’t intend on using the equipment for a long time, disconnect it from the power outlet to
prevent being damaged by transient over-voltage.
 Keep all liquids away from the equipment to minimize the risk of accidental spillage. Liquid spilled on
to the power supply or on other hardware may cause damage, fire or electrical shock.

Only qualified service personnel should open the chassis. Opening it yourself could damage the
equipment and invalidate its warranty.
 If any part of the equipment becomes damaged or stops functioning, have it checked by qualified
service personnel.
1.3 Regulatory Notices Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
Any changes or modifications made to this equipment may void the user’s authority to operate this equipment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
 Re-position or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.