Thermolec Split|Steam - Manual (Page 31)

CONTRACT
OR
Page 29
Number of
fl
ashes
of
the
red light
Error Description
Humidi
fi er
Status
Actions
to
be
T
aken
by the T
echnician
Reset
OFF
No error
The humidi
fi
er is working
fi ne
None
Countinuous
ON
The
fl
ood sensor under the tank
senses water in the pan.
Humidi
fi
er immediately suspends the
ongoing operation. Heating elements and supply valve are switched of
f.
T
urn the main power OFF
, then
- Check the drain tube - Check for abnormal leaks
Automatic Reset when switching main power ON
1
The two water level sensors are miswired or do not read the water level properly
.
Humidi
fi
er attempts to operate, then
stops because of wrong information from water level sensors.
T
urn the main power OFF
, then
- Check that the water level sensors are in the right order -
Clean
the
sensors
Automatic Reset when switching main power ON
2
This code is not used on this model - Reserved for future use
3
Inadequate water supply
.
The
supply valve was open for more than 4 minutes.
Humidi
fi
er immediately suspends the
ongoing operation. Heating elements and supply valve are switched of
f.
T
urn the main power OFF
, then
check the water supply circuit
Automatic Reset when switching main power ON
4
Inadequate drainage.
The tank
did not drain or the draining cycle is too long.
Humidi
fi
er immediately suspends the
ongoing operation. Heating elements and supply valve are switched of
f.
T
urn the main power OFF
, then
check the drain tube
Automatic Reset when switching main power ON
5
The fan is not running.
Humidi
fi
er immediately suspends
the ongoing operation.
The unit goes
back to normal operation as soon as the error condition disappears.
Check the wiring between the fan module and steam generator
.
Automatic Reset when error conditions disappear
6
T
emperature inside the tank
exceeded the high temperature cut-out setting.
The high temperature cut-out has tripped. The
humidi
fi er
immediately
suspends the ongoing operation. Heating elements and supply valve are switched of
f.
T
urn the main power OFF
, then
- Check the steam hose for kinks or blockage -
This is a very serious condition
After pushing on the thermal cut-out button, automatic reset when switching main power ON
22. Detailed Error Codes