Anschutz 1700 - Manual (Page 9)

32
1720
Caliber:
.22 Win. Mag. R.F.
Barrel length: 58 cm / 23“
Total length: 108 cm / 43.5“
Weight approx.: 3.4 kg / 7.5 lbs
Magazine:
4-shot
1730
Caliber:
.22 Hornet
Barrel length: 58 cm / 23“
Total length: 108 cm / 43.5“
Weight approx.: 3.4 kg / 7.5 lbs
Magazine:
5-shot
1740
Caliber:
.222 Remington
Barrel length: 58 cm / 23“
Total length: 108 cm / 43.5“
Weight approx.: 3.4 kg / 7.5 lbs
Magazine:
3-shot
1740 E
Caliber:
.222 Remington
Barrel length: 58 cm / 23“
Total length: 107 cm / 43“
Weight approx.: 3.9 kg / 8.6 lbs
Version:
Single loader
Heavy Barrel rifles are approx. 0.3 kg /
0.6 lbs heavier.
Assembly, fitting the
ANSCHÜTZ barreled action
The stock and the barreled action are
packed separately for shipment and need
to be assembled. However, do not do this
until you have followed all the procedures
listed below.
•Wipe away excess oil from the surface
of the barreled action.
•Insert the bolt and make sure that the
safety catch at rear of the bolt is parallel
to the bolt handle. If not, hold the bolt at
the bolt handle and press the safety
catch upwards. Holding the bolt handle
horizontal, insert bolt in the receiver and
push smartly forward. Make sure not to
damage the stock when inserting the bolt.
Please also see chapter „ANSCHÜTZ
bolt“.
•Pull a cleaning patch through the barrel
from the chamber towards the muzzle
several times.
Cocking, loading and safety
operation
•Degrease the bolt and the interior of the
barrel without leaving lint.
•Open the reinserted bolt and pull it back
to the stop.
•Now push the bolt forward to close the
breech. A cartridge from the magazine
is fed into the chamber of the barrel.
Now push the bolt handle completely
downwards. The bolt is now cocked, the
rifle is ready for shootihng.
•After firing, lift the bolt handle and pull
the bolt fully to the rear. This will cock
the bolt again and eject the empty case.