Torque specifications – Wright Serial #49705 and Higher User Manual
Page 18
17
Critical Application
Models
Thread
Locker
Torque
Range (ft-lbs)
Torque
Sticks
Wheel motor bolts (Securing
motor to support)
Big/Small Stander, RH,
WSES, Velke
Loctite
2760
40-50
50
Wheel motor bolts / nuts
(Securing motor to support)
ZK, MMZ, Sentar3
N/A
103-125
110
Clutch to engine shaft
All Models
Loctite
2760
50-55
50
Big Stander (MF14)
175-225
160
ZK, MMZ, Sentar3 (15E)
160-240
160
All Others (12P)
138-158
130
Wheel lug nuts
All Models
N/A
80-90
90
Split Hub (Spindle & Drive) (Gr 8) All Models
N/A
13-17
n/a
N/A
Wheel hub to wheel motor
Torque Specifications
Spindle and Drive Pulley Split hub R&R
•
Remove 2, ¼” bolts from split hub and install in threaded holes in hub.
•
Slowly tighten each bolt, alternating as you tighten bolts against the pulley.
•
The hub will separate from the pulley.
•
Replace grade 8 bolts and install in reverse order using the assembly holes to tighten hub onto pulley
and spindle shaft.
Assembly hole
Threaded Removal holes
Assembly hole
Tightening will separate the
hub from the pulley