Wright Pre Serial #43181 User Manual
Commercial mower owner’s manual, Warning: read this manual before using
Table of contents
Document Outline
- Pre-Delivery Service of Mower by Dealer
- SAFETY INSTRUCTION MANUAL
- OPERATING INSTRUCTIONS
- How to start the mower
- Before starting the engine
- Starting the engine
- How to Drive the Mower Over a Curb
- Never drive straight onto or off a curb.
- How to Use the Mower on Varying Terrain
- How to Adjust Neutral
- How to Change the Speed/Sensitivity Adjustment
- How to Perform the Tracking Adjustment
- Test/Use the Blade Clutch/Brake Switch
- How to Test the Operator Presence Control (OPC) Switch
- Service and Adjustments
- Tire Maintenance and Pressure
- Height-of-Cut
- Deck Adjustments
- The mower deck can be adjusted for pitch and side-to-side lever. Pitch is the relationship between the front of the deck and the rear of the deck in regards to height of cut. In most cases, a positive pitch (front of the deck lower than the rear of the deck) of ¼” is the optimum setting. These two adjustments can easily be made by using the deck lift rod assemblies attached to the front deck arms and the threaded deck hangers located at the rear of the deck frame. These hangers are connected to the chains that hold the deck. Adjust the rear deck hangers (by using a socket through the hole above the toe area of the platform) to achieve a ¼” pitch. These hangers are right-handed threads. If you raise any of these settings above the factory setting, the deck may not raise all the way up into transport position. Be sure and check the deck height of cut range after any adjustments are made to these hangers to ensure that the height of cut adjustments work properly. If unable to make the adjustments needed by only using these hangers, contact your dealer for assistance.
- Belt Tension Adjustment
- How to Move the Mower if the Engine Won’t Start
- Bleeding Air from the Hydraulic System
- Battery Service
- Cleaning the Mower
- How to start the mower
- Maintenance Record