beautypg.com

Wright Pre Serial# 17124 User Manual

Page 18

background image

40 hours intervals (Do the following plus all

items done at 5-10 hour intervals)

Blade drive belt tension adjustment should be

checked at forty (40) hour intervals except
new belts should be checked at four to five (4-
5) hours and at eight to ten (8-10) hours

Change engine oil if using synthetic (Mobil 1 or

AmsOil), or change every eight (8) hours if not
synthetic oil*

Thoroughly clean complete mower

Grease caster wheel bearings, (2) points

Grease caster wheel pivots, (2) points

Grease blade spindle bearings, (2-3) points

Check tire pressure

Lubricate foot platform Operator Presence

Control pivots and control rod with water-
proof grease, (3) points

Lubricate hand control lever pivot shafts with

waterproof grease (4 places)

Lubricate throttle control cable with WD-40

Lubricate choke control cable with WD-40 (if

equipped)

Check hydraulic reservoir oil level; The level

should be about 4"-5" below the top of the oil
fill. Use synthetic oil: Mobil 1 10W-30 or
AmsOil 10W-40.

Inspect and replace worn tires

Adjust both parking brake shoes to firmly stop

wheels

160 hour intervals or annually (Do the follow-

ing plus all items done at 5-40 hour inter-
vals)

Clean or replace spark plugs (see engine

manual)

Replace engine oil filter with oil change*

Replace hydraulic oil filter with original Wright

25 micron filter at first 160 hour interval* (and
annually thereafter*)

Check hydraulic reservoir oil level*; The level

should be about 4"-5" below the top of the oil
fill; use synthetic oil: Mobil 1 10W-30 or
AmsOil 10W-40

Completely inspect for excessive wear in all

parts of mower, including control system,
replace worn parts

Check both set screws on each hydraulic

pump pulley and engine pulley (for pump
belt) for tightness, 2 each on pump pulleys, 1
on engine pulley, 5 total

Remove and clean battery box (if equipped)

Completely inspect for cracks in frame, tractor

frame or other steel parts and have autho-
rized dealer weld any found

Annually (Do the following plus all items

done at 5-160 hour intervals)

Replace hydraulic oil filter with original Wright

25 micron filter at 160 hour intervals and
annually thereafter*

Check hydraulic reservoir oil level; The level

should be about 4"-5" below the top of the oil
fill; use synthetic oil: Mobil 1 10W-30 or
AmsOil 10W-40

Replace all excessively worn spindle bearings

(after three years only)

Replace excessively worn main cutter deck

idler pulleys

Replace excessively worn caster wheels and

roller bearings

Replace excessively worn caster pivot bushings

Remove cotter pins and check torque on both

castle nuts on center of drive wheel hubs to at
least 175 ft.-lbs. Replace with new cotter pins.

page 15