Pfister E34-BNFC User Manual

Page 6

Thank you for purchasing this Price Pfister kitchen faucet. All Price Pfister products are carefully engineered, and factory tested to provide long trouble-free use under

normal conditions. This kitchen faucet is easy to install using basic tools and our easy to follow illustrated instructions. If you have any questions regarding your kitchen

faucet installation call 1-800-Pfaucet (1-800-732-8238).

BEFORE PROCEEDING

Locate water supply inlets and shut off the water supply valves. These are

usually found under the sink or near the water meter. If you are replacing an

existing faucet, remove the faucet from the sink and clean the sink surface

thoroughly.

TOOLS RECOMMENDED

Pliers

Flashlight

9/16” and 11/16” open end wrenches

Adjustable wrenches (optional)

Plumber’s putty

Flaring tool (for copper tube installations)

Your installation may require supply tubes and / or shut-off valves.

1A INSTALLING OPTIONAL DECK PLATE

(For single hole mount, go to step 1B)

Ensure that plastic putty plate (A) is pressed on to deck plate (B). Place

a bead of plumber’s putty in the goove along the outer edge of the putty

plate (A). Install the deck plate (B) over the three holes in your sink. From

underneath sink, hand tighten wing nuts (C). Caution: do not over tighten

wing nuts. Remove any excess putty from around the outside edge of the

deck plate (B). To continue with the installation, go to step 2A.

1B INSTALLING SINGLE POST RING

Pass single post ring (A) over copper inlet / outlet tubes (B), and press onto

faucet body (C). Note: The tabs on the faucet body (C) must be aligned to the

grooves inside the single post ring (B). To ensure this is the case, rotate the

single post ring (B). When the tabs are aligned, the ring will cease to rotate.

2A INSTALLING THE FAUCET USING THE OPTIONAL DECK PLATE

Ensure that the mounting gasket (A) is pressed frimly in to the faucet body

(B). Feed the pull-out hose (C) up through the faucet body (B), until the

pull-out hose fitting is flush with the bottom of the mounting shank (D) (see

illustration). Insert the faucet supply tubes (E) and mounting shank (D)

through the hole in the deck plate (F). Note: The tabs on the faucet body (B)

must be aligned to the grooves inside the deck plate (F). To ensure this is the

case, rotate the faucet body (B) back and forth. When the tabs are aligned, the

faucet will cease to rotate.

Modèle E34-FNFC représenté

FRANÇAIS

This manual is related to the following products:

E34-ENFC E34-VNFC