Multi-tasker – Altinex MT108-102 User Manual
Page 9
MULTI-TASKER
8
Example:
1.
[ON1G5U1]: Turns ON output 1 for each
card in group 5 of unit 1.
2.
[ONG5U1]: Turns ON all outputs for each
card in group 5 of unit 1.
[ON…P]: sets path
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card can be
preloaded.
Command Format: [ONmCnUiP]
m
= number (m =1 to 4)
n
= card ID No. (n = a slot # from 1 to 19)
i
= unit ID
P
= path
Example:
If 2 cards are in slot 6 and 7 of unit 3: To enable
outputs 1 and 2 of card 6 and outputs 3 and 4 of
card 7 simultaneously, use the following
commands:
[ON12C6U3P]
[ON34C7U3P]
[SW]
If "F" is included use the [ONmCnUiPF]
command or the [ONmCnUiFP]
command.
[ON…..F]: feedback
After processing a command, an OK or ER will
be returned as feedback if "F" is included at the
end of a command string.
Example:
[ON1C2U3F]: if path is not set
[ON1C2U3PF]: if path is set
6. [OFF]
This command disables one or more outputs of
a single card or a group of cards.
[OFFmCnUi]: for a single card
This command disables output “m” without
affecting any other outputs.
m
= output number (m = 1 to 4)
n
= card ID No. (n = slot # from 1 to 19)
i
= Unit ID number (i = 0 to 9)
[OFFCnUi]: Turns OFF all outputs of the card
Example:
1)
If card 5 of unit 3 has output 1, 2 and 3 ON:
a)
[OFF1C5U3]:
Turns OFF output 1 while
outputs 2 and 3 remain ON.
b)
[OFF23C5]:
Turns OFF outputs 2 and 3.
2)
If card 5 of unit 3 has outputs 1, 2, 3 and 4
ON:
a)
[OFFC5U3]:
Turns OFF all outputs,
which is equivalent to
[OFF1234C5U3].
[OFFmGkUi]: for a group of cards
This command disables output "m" for each
card in group "k" of unit "i".
Command Format: [OFFmCnUiP]
m
= card output (m = # from 1-4)
k
= group number (k = # from 1-9)
i
= unit number (i = # from 0-9)
Example:
1.
[OFF1G5U1]: Turns OFF output 1 for each
card in group 5 of unit 1.
2.
[OFFG5U1]: Turns OFF all outputs for each
card in group 5 of unit 1.
[OFF…..P]: sets path
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card can be
preloaded.
Command Format: [OFFmCnUiP]
m
= number (m =1 to 4)
n
= card ID No. (n = a slot # from 1 to 19)
P
= path