Pfister F-048-LHKK - Manual (Page 3)

ENGLISH
ENGLISH
8
7
9
10
DRAIN BODY INSTALLATION
FAUCET FUNCTIONS
11
12
7 WATER SUPPLY CONNECTIONS
Connect water Supply Lines (7A) to Faucet Inlets (7B). Hot water supply lines go into
left inlet. Cold water supply lines go into right inlet. (Supply lines are not included).
Please follow manufacturer’s instructions when installing supply lines.
8 POP-UP ROD CONNECTION
Insert Lift Rod (8A) into hole at the back of Spout (8B).
9 POP-UP INSTALLATION
Install and adjust Pop-Up (9A) using separate instructions supplied with the Pop-Up
assembly.
10 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
11 FAUCET FUNCTIONS
COLD valve: close-counterclockwise, open-clockwise; HOT valve: close-clockwise,
open-counterclockwise. The Spout (11A) can be rotated around the Faucet Body in
any direction.
Note: Flush faucet before turning on valve (see step 12).
12 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (12A). Turn Valves (12B) on
and allow both hot and cold water to run for at least one minute each. While water is
running, check for leaks. To clean the aerator, disassemble Aerator Housing (12A) by
separating the Aerator Shell (12C), Basket (12D) and Washer (12E). Once parts have
been cleaned, reassemble by reversing steps.
3
9A
8B
8A
11A
7B
7A
7A
7B
HOT
COLD
HOT COLD
OPEN OPEN
12A
12E
12D
12C
12B