Avanti WC3201D - Manual (Page 3)

3
IMPORTANT SAFEGUIDES
Before the appliance is used, it must be properly positioned and
installed as described in this manual, so read the manual carefully. To reduce the
risk of fire, electrical shock or injury when using the appliance, follow
basic precaution, including the following:
?
Plug into a grounded 3 -prong outlet, do not remove grounding prong, do not use an ad apter, and
do not use an e xtension cord.
?
Replace all panels before operating .
?
It is recommended that a separate circuit, serving only your appliance be provided. Use
receptacles that cannot be turned off by a switch or pull chain.
?
Never clean appliance parts with flammable fluids. These fumes can create a fire hazard or
explosion. And do not store or use gasoline or other flammable vapors and liquids in the vicinity of
this or any other appliance. The fumes can create a fire hazard or explosion.
?
Before proceeding with cleaning and m aintenance operations, make sure the power line of the
unit is disconnected.
?
Do not connect or disconnect the electric plug when your hands are wet.
?
Unplug the appliance or disconnect power before cleaning or servicing. Failure to do so can result
in electrical shock or death.
?
Do not attempt to repair or replace any part of your wine chiller unless it is specifically
recommended in this material. All other servicing should be referred to a qualified technician.
?
Use two or more people to move and insta ll appliance . Failure to do so can result in back or other
injury.
?
To ensure proper ventilation for your appliance, the front of the unit must be completely
unobstructed. Choose a well -ventilated area with temperatures above 55
0
F (13
0
C) and below
90
0
F (32
0
C). This unit must be installed in an area protected from the element, such as wind, rain,
water spray or drips.
?
The appliance should not be located next to ovens, grills or other sources of high heat.
?
The appliance must be installed with all electrical, water and drain connections in accordance with
state and local codes. A standard electrical supply (115 V AC only, 60 Hz), properly grounded in
accordance with the National Electrical Code and local codes and ordinances is required.
?
Do not kink or pinch the power supply cord of refrigerator.
?
The fuse (or circuit breaker) size should be 15 amperes.
?
It is important for the appliance to be leveled in order to work properly. You may need to make
several adjustments to level it.
?
All installation must be in accordance with local plumbing code requirements.
?
Make certain that the pipes are not pinched or kinked or damaged during installations .
?
Check for leaks after connection.
?
Never allow children to operate, play with or crawl inside the appliance.
?
If you use the drainage container , you MUST set the Drain Select switch to OFF or the water can
overflow from the drainage container
?
Although the unit has been tested at the factory, due to long-term transit and storage, the first
batch of cubes must be discarded.
?
Do not use solvent-based cleaning agents of abrasives on the interior. These cleaners may
damage or discolor the interior.
?
Do not use this apparatus for other than its intended purpose.