Rapid-Air SERVO FEED WITH PILOT RELEASE: KBX SERIES - Manual (Page 28)

27
TROUBLESHOOTING CHART (cont.)
PROBLEM CAUSE REMEDY
Material feeds off Edge guides not set Set edge guides
center properly
Material not centered Center material
to feed
Bad Material Try new roll of material
No automatic cycle No press signal Check limit switch
input to servo control
Controller fault Check lights on drive
Servo fault Check lights on drive
Program error Check parameters
on display
Servo squeals while Servo velocity gain Consult factory
too high
Belt too loose or tight Readjust belt tension
Fault signal on Pac-Sci Servo fault Recycle power
is displayed Material jam Check die
Power surge/failure Check/recycle power
Cannot program unit Program fault Check Pac-Sci &
from display call factory.
Data Instruments Check Data Instruments
interface jumper loose connection