Qualcraft Daytona Big Block SRL - Manual (Page 15)

Labels
G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
13
WARNING: Prior to
use, fully read and
understand all
manufacturer’s instructions
provided with equipment at time
of shipment. DO NOT ATTEMPT
TO SELF SERVICE OR REPAIR!
DO NOT REMOVE THIS LABEL.
USE: Always use in accordance
with manufacturer’s instruction
manual and labels included
with this device at the time
of shipment. This device is
only for use by one person
as a fall arrester. Always
connect the snap hook
directly to the attachment
point on the safety harness.
Guard against swing-falls
by keeping the lifeline
vertically overhead.
Maximum free fall 2 feet.
Avoid lifeline contact
with sharp or abrasive
edges and surfaces.
Ensure that
connection to
anchorage is secured
properly before use.
May be used as a
component of a PFAS in
HLL applications. Design,
installation, and utilization
of HLLs must be
supervised by a Qualified
Person. Suitable for
horizontal use. Competent
Person must calculate
adequate fall clearance prior
to use; refer to instructions
for details. Minimum
installation setback distance
from leading edge is 6 feet.
MADE IN U.S.A.
INSPECTION:
Inspect unit in
accordance to the
manufacturer’s instruction
manual and regulatory guidelines.
Check lifeline retraction by pulling
out a minimum 4 feet of lifeline
and allowing it to retract under
light tension, lifeline should
retract completely. Pull sharply
to test locking function, brakes
must engage. Before use,
inspect the lifeline condition,
function and condition of
fasteners, and legibility of
labels. Also, check for
evidence of defects, damage
or missing parts. User must
inspect the impact indicator
for signs of activation.
Device must be taken out
of service after arresting a
fall or if the impact
indicator show signs of
activation. Do not use if
inspection reveals an
unsafe condition. Unit
must be inspected by
a trained and
Competent Person at
least every 6 months.
SPECIFICATIONS:
Capacity Range: 130 – 310
lbs. or 311 – 420 lbs.*
*See instructions.
Average arresting force:
900 lbs.
Maximum arresting force:
1,800 lbs.
Maximum arresting distance:
54 in.
Class B SRL
STANDARDS:
OSHA 1926 Subpart M, OSHA
1910, ANSI Z359.14-2014, & ANSI
A10.32-2012
90150 (Rev. D)
10968 65’; 3/16” CABLE
CUSTOM #
Date of First Use Mfg. Date
J F M A A J M J S O N D
YR
YR
YR
YR
YR
Serial #