Qualcraft Float Tux Harness - Manual (Page 14)

G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
12
1. Hold at dorsal D-ring,
and fully inspect harness
according to specifications
of this instruction manual.
Ensure all straps are not
twisted and all buckles
are unfastened. 2. Connect leg straps
around thighs. Ensure
there is no twisting of
webbing. Leg straps
should never dangle
or hang loose. 3. Adjust chest strap
height to lower chest
level, approximately 6”
from top of shoulders.
Connect chest strap.
Ensure there is no
twisting of webbing.
4. Adjust chest and leg
straps so they fit snugly,
but still allow for a full
range of movement.
Some steps of adorning a
harness may require assistance
from another person.
Upon completely adorning
a harness, Guardian Fall
Protection recommends that
another person, with knowledge
of the safe and correct
use of the harness, inspect
to ensure the harness is
being worn correctly.
Any twisting of webbing, or
straps that are fitted too loose
or too tight, can significantly
increase the risk of serious
injury or death in the
event of a fall.
! WARNING
1
2
3
4