Qualcraft Surveyor's Construction Tux - Manual (Page 13)

Installation and Use
Guar
d
ian F
al
l Pr
o
tection
6305 S. 231s
t St
., K
e
nt
, W
A
98032
phone: (800) 466
-6385 f
ax
: (800) 670
-7892
www
.guar
d
ianf
al
l.c
o
m
11
ALWAYS follow all instructions of all equipment used
in combination with the Construction Tux Harness.
ALWAYS ensure all product-specific application specifications are met and adhered to.
NEVER attach connector to any place on harness other than D-ring.
Connector gate must be self-closing and self-locking, and must
withstand minimum load of 3,600 lbs.
ALL PFAS equipment must be selected and deemed compatible with
the Construction Tux Harness by a Competent Person.
To connect Pass-Through Buckle, angle male buckle so it
is positioned to pass up and through female buckle.
Fully insert male buckle so that it lies flat on top of
female buckle.
To connect Tongue Buckle, pull webbing strap through
framed tongue component, and insert framed tongue
through grommet to secure.
Dorsal D-ring, chest strap, shoulder straps, and leg straps
MUST be fitted for each individual user.
To adjust dorsal D-ring, slide placard up or down webbing.
Dorsal D-ring must rest between the middle of the
shoulder blades.
Roller and Friction Adjustments allow the user to make
adjustments to Velocity Harness straps. Feed webbing through
buckle, and slide the buckle down on the strap to tighten, or
slide the buckle up on the strap to loosen.