Powermate 024-0179CT - Manual (Page 7)

7 - ENG
ACCESSORIES ACCESSORIES
Fastener Part
Number
Description Size
Qty per
stick/row
Qty per
box
103-0138CT Brad Nail Length - 1” (25mm)
Size - 18 Gauge 100 1,000
103-0139CT Brad Nail Length - 1-1/4” (32mm)
Size - 18 Gauge 100 1,000
103-0137CT Crown staple Length - 5/8” (16mm)
crown Series 90 100 500
103-0136CT Crown staple Length - 1-1/4” (32mm)
6mm crown Series 90 100 500
Use only fasteners made or recommended by Coleman Powermate.
TROUBLESHOOTING GUIDE TROUBLESHOOTING GUIDE
SYMPTOM POSSIBLE CAUSE(S) CORRECTIVE ACTION
Tool will not cycle No oil in tool Add 4-6 drops of air tool oil into the air inlet of the tool (see
“user maintenance” section).
Low air pressure Adjust compressor regulator to 60-100 PSI.
Air hose leaks Tighten and seal hose fittings with Teflon® tape if leaks are
found.
Fastener does not go in far
enouth into the work surface Air pressure set too
low Adjust the compressor regulator to a higher setting. Do not
exceed 100 PSI.
Fastener goes too deeply
into the work surface Air pressure set too
high Adjust the compressor regulator to a lower setting.
Fasteners keep jamming in
tool Incorrect fasteners for
the tool Use only the fasteners identified for use with this tool (see
Accessories section of this manual). Read the User
Maintenance section of this manual to clear jams from the
tool.
Fasteners are dirty or
bent Replace with clean undamaged fasteners. Read the User
Maintenance section of this manual to clear jams from the
tool.
ONE YEAR LIMITED WARRANTY: Powermate Corporation (the Company) warrants that for a period of twelve (12)
months from the date of purchase, it will replace or repair, free of charge, for the original retail purchaser only, any
part or parts, manufactured by the Company, found upon examination by the Company or its assigned representa-
tives, to be defective in material or workmanship or both. All transportation charges for parts submitted for replace-
ment or repair under this warranty must be borne by the original retail purchaser. This is the exclusive remedy under
this warranty.
Failure by the original retail purchaser to install, maintain and operate said equipment in accordance with good indus-
try practices, or failure to comply with the specific recommendations of the Company set forth in the owner’s manu-
al, shall render this warranty null and void. The Company shall not be liable for any repairs, replacements, or adjust-
ments to the equipment or any costs for labor performed by the purchaser without the Company’s prior written
approval. The effects of corrosion, erosion and normal wear and tear are specifically excluded from this warranty.
THE COMPANY MAKES NO OTHER WARRANTY OR REPRESENTATION OF ANY KIND WHATSOEVER,
EXPRESSED OR IMPLIED EXCEPT THAT OF TITLE. ALL IMPLIED WARRANTIES, INCLUDING ANY WARRAN-
TY OF MERCHANTABILITY AND FITNESS FOR PARTICULAR PURPOSE ARE HEREBY DISCLAIMED. LIABIL-
ITY FOR CONSEQUENTIAL AND INCIDENTAL DAMAGES UNDER ANY AND ALL WARRANTIES, OTHER CON-
TRACTS, NEGLIGENCE, OR OTHER SORTS IS EXCLUDED TO THE EXTENT EXCLUSION IS PERMITTED BY
LAW.
Notwithstanding the above, any legal claim against the Company shall be barred if legal action thereon is not com-
menced within twenty-four (24) months from the date of purchase or delivery whichever occurs last. This warranty
constitutes the entire agreement between the Company and the original retail purchaser and no representative or
agent is authorized to alter the terms of same without expressed written consent of the Company.
LIMITED W LIMITED W ARRANTY ARRANTY